Practical and Helpful Tips: Products

A Guide to Fixing of the Deadbolt on Your Door

Rather than trusting the security of your home with the spring-loaded door knob, the deadbolts offers enhanced security. A deadbolt can only be initiated using a key from any side. It is not complicated if you need to place a deadbolt for your door. Most of the manufacturers have a template instruction you on how to install it. However, you will find the process much easier after you read this article.

Start by reading on the manufacturer's instructions template. It has reference indicating points to marked on the door using an awl. It should be at least six inches above the door knob.

Drilling a hole for the deadbolt should follow. The holes are to be made to the points marked according to the manufacturer's template. Cut the holes using a hole saw.Finishing the hole from the other side of the door will prevent splinters. Of your hole saw is not big enough to go through the breadth of the door use a standard bit to drill.
If You Think You Understand Products, Then This Might Change Your Mind

Drilling a hole through the edge of the door is the third step. The 211/2" spade bit drill will have to be used here. Mortise the area around the faceplate. You need to use the wood chisel to mortise it so that it is flush with the door. A smaller chisel might be required to mortise the rounded corners.
5 Uses For Deadbolts

Fastenig the bolt to the door follows. Mortising will be required until the faceplate fits right. Drill the pilot holes and secure the deadbolt to the door using screw.

The installation of the cylinder and the thumb level is what follows. Start of fixing the exterior side and ensure that the writing is upright. Proceed to the interior where you will tighten the screws with the mounting holes inside the lock. To fasten the deadbolt, make use of screws.

Use lipstick or paint to mark the end of the bolt. Mark the door frame by first shutting the door and turning the bolt many times. The 7/8" spade bit should be applied to drill two holes in the door frame for the deadbolt. Mortise the surrounding of the holes such that the strike bolt will be flush with the door frame. Fasten the bolts using screws on the holes made.

This done, your home will be under higher security than it would be on a standard spring loaded door knob.Alternative, you can seek expert services for the installation of the deadbolt for your door in case you find it tough. There are possibilities of doing mistakes when you do it yourself and they can be costly. Such a case is when you fail in a procedure which will leave ugly marks on your door, and you won't like it.Keeping an eye on the manufacturer's template and the guide to help you get it right.